And for other side of 3.5 caddy you need to remove front panel to place screws. No 3.5 mech drives rails provided, just screws, where only one side exposed for tightening and requires half size philips screw driver.
NZXT S340 PRICETRACKER DRIVERS
( its a con because thumb screws suppose to be open by fingers, not screw drivers ) At 70 bucks it a good case.Ĭons: - tight thumb screws due to poor threading of metal for side panels, you gotta use screw driver.
NZXT S340 PRICETRACKER INSTALL
I mentioned it has every possible shortcut hole for cable management ? Including back of mobo open thus heat sink install can be done on installed motherboard with out disassembly for back plate switch. Also it has crazy rubber feet ! They like 1 inch tall and super sticky to surface it sits on, it will not slide or shift if you try it. Dual usb 3 on front panel is good, uses single usb 3.0 connector to mobo. Back of mobo have almost 1 inch space for wires which are good for cable management. Has 2 spots for mech drives 3.5 inch, and couple spots for 2.5 ssd which resting on PSU cover. Filters from front and under the psu are nice! For clean intake.
It have spot to mount Corsair h55 cooling rig with single radiator or dual one upfront, there no fans there, you put fans from radiator on suction, because top and rear one for exhaust and mounted as such. Same goes for nice looking expensive PSU - no one will see it ) Cover provides a lot of space for loose wires as well. It has that modern cover for PSU, so if you have cheap PSU it will be covered up. A lot of nice zip tie spots for holding wires. Like the blue bar on inside, which covers 24 pin PSU wire and sata wires to mobo ports. Pros: Very good looking solid metal case. Integrated PSU shroud for ultra clean buildĪdditional Information Date First Available Very easy to build in for new and experienced users alike Grommet-less cable management bar keeps cables tidy with easeįull 280mm radiator support for the latest Kraken coolerĬompact form factor coming in two inches below competing mid towersĭetailed design and engineering with tons of small touches Rear: 1 x 120mm fan (1 x 120mm FN V2 Fan Included)įront - Up to 240mm / Front - Up to 280mm / Rear - Up to 120mmģ60 degree of steel casing surrounding the all-steel chassis Top: 1 x 120/140mm fan (1 x 120mm FN V2 Fans Included) Despite its small size, it’s still compatible with the company’s Kraken X61 and X31 liquid coolers.Learn more about the NZXT S340_Blue Model Brand The side panels are also very thick, and one side has an enormous window to showcase your build.Ĭoming in at 445mm high and 432mm long, the US$69.99 S340 also axes the front 5.25-inch bays and relocates the hard drives to a lower position.
NZXT S340 PRICETRACKER PC
Cable management should be a breeze with this case, thanks to twenty cable management (zip-tie) points, and little details like steel plated audio jacks and captive thumb screws.Ī premium PC case, the S340 comes with standard accouterments, such as USB 3.0, filtered intakes, and a PSU shroud. With 90% steel construction, the S340 touts a smart interior layout, aided by a grommet-less steel cable management bar splitting the front intake from the rest of the case. NZXT, maker of avant-garde gaming PC hardware, has just announced the Source 340 (S340) mid-tower PC case.
The NZXT S340 is a compact mid-tower PC case made up of mostly steel
0 kommentar(er)
